frage steht oben...

Danke

sehe gerade, die 1 gig reigel gibt es nur mit cl5...hat die wer...?

Ich hab das MDT DIMM Kit 2048MB PC2-6400U CL5 (DDR2-800) (M2GB-800K)

Die SPD Daten mit Everest ausgelesen:

Modulname MCI Computer MDT 1GB DDR2-80
Seriennummer 7F17200Ah (169875327)
Herstellungsdatum Woche 21 / 2007
Modulgröße 1024 MB (2 ranks, 4 banks)
Modulart Unbuffered DIMM
Speicherart DDR2 SDRAM
Speichergeschwindigkeit DDR2-800 (400 MHz)
Modulbreite 64 bit
Modulspannung SSTL 1.8
Fehlerkorrekturmethode Keine
Auffrischungsrate Reduziert (7.8 us), Self-Refresh

Speicher Timings
@ 400 MHz 6-5-5-18 (CL-RCD-RP-RAS) / 23-30-3-6-3 (RC-RFC-RRD-WR-WTR)
@ 400 MHz 5-5-5-18 (CL-RCD-RP-RAS) / 23-30-3-6-3 (RC-RFC-RRD-WR-WTR)
@ 266 MHz 4-4-4-12 (CL-RCD-RP-RAS) / 16-20-2-4-2 (RC-RFC-RRD-WR-WTR)

super...kannst du das komplette SPD bitte mal mit folgendem tool auslesen und abspeichern...

http://forums.techpowerup.com/showthread.php?t=20349

einfach entpacken und die spdtool.exe starten...dann...:

file read

dann

file save

und mir das dann schicken

das wäre super

OK, wo soll ich es Dir hinschicken?

Ich hab jetzt einfach mal das komplette untere Fenster hier reinkopiert. Kann Dir aber auch gern das File schicken.


Number of Serial PD Bytes written during module production 128
Total number of Bytes in Serial PD device 256
Fundamental Memory Type DDR2 SDRAM
Number of Row Addresses on this assembly 14
Number of Column Addresses on this assembly 10
Number of DIMM Ranks 2
Card On Card Yes
DRAM Package Planar
Module Height 30.0 mm
Module Data Width 64
Voltage Interface Level of this assembly SSTL 1.8V
SDRAM Cycle time at Maximum Supported CAS Latency 2.50 ns (400 MHz)
SDRAM Access from Clock 0.40 ns
DIMM error detection/correction features None
Refresh Rate Reduced 7.8 uS
Primary SDRAM Width 8
Error Checking SDRAM Width 0
Burst Lengths Supported 4, 8
Number of Banks on SDRAM Device 4
CAS Latencies Supported 4, 5, 6
Module Thickness <4.10 mm
DIMM Type UDIMM
Analysis Probe Installed No
FET Switch Available No
Number of PLLs on the DIMM 0
Numer of Active Registers on the DIMM 0
Support Weak Driver Yes
Supports 50 Ohm ODT Yes
Supports PASR (Partial Array Self Refresh) Yes
Minimum Clock Cycle at CLX-1 2.50 ns / 17.50 ns (400 MHz)
Maximum Data Access Time (tAC) from Clock at CLX-1 0.45 ns
Minimum Clock Cycle at CLX-2 3.75 ns (267 MHz)
Maximum Data Access Time (tAC) from Clock at CLX-2 0.50 ns
Minimum Row Precharge Time (tRP) 12.50 ns
Minimum Row Active to Row Active delay (tRRD) 7.50 ns
Minimum RAS to CAS delay (tRCD) 12.50 ns
Minimum Active to Precharge Time (tRAS) 45 ns
Module Rank Density 512 MB
Address and Command Input Setup Time Before Clock (tIS) 0.15 ns
Address and Command Input Hold Time After Clock (tIH) 0.22 ns
Data Input Setup Time Before Strobe (tDS) Undefined
Data Input Hold Time After Strobe (tDH) 0.12 ns
Write recovery time (tWR) 15.00 ns
Internal write to read command delay (tWTR) 7.50 ns
Internal read to precharge command delay (tRTP) 7.50 ns
Minimum Active to Active/Refresh Time (tRC) 57.00 ns
Minimum Refresh to Active/Refresh Command Period (tRFC) 75.00 ns
Maximum device cycle time (tCKmax) 8.00 ns
Maximum skew between DQS and DQ signals (tDQSQ) 0.20 ns
Maximum Read Data Hold Skew Factor (tQHS) 0.30 ns
PLL Relock Time Undefined
SPD Revision 1.2
Manufacturer’s JEDEC ID Code MCI Computer GMBH
Module Manufacturing Location 49
Module Part Number MDT 1GB DDR2-80
Module Revision Code 3031
Module Manufacturing Date Week 15 07
Module Serial Number 7F17200A
EPP Identifier EPP Not supported
EPP Profile Type Undefined
EPP Profile for Optimum Performance Profile 1
EPP Enabled Profiles #2
EPP Profile 0 Voltage Level Undefined
EPP Profile 0 Address Command Rate 1T
EPP Profile 0 Address Drive Strength 1.00x
EPP Profile 0 Chip Select Drive Strength 1.25x
EPP Profile 0 Clock Drive Strength 1.00x
EPP Profile 0 Data Drive Strength 1.00x
EPP Profile 0 DQS Drive Strength 1.25x
EPP Profile 0 Addr/CMD Fine Delay 4/64 MEMCLK Delay
EPP Profile 0 Addr/CMD Setup Time 0.5 MEMCLK
EPP Profile 0 Chip Select Fine Delay 5/64 MEMCLK Delay
EPP Profile 0 Chip Select Setup Time 0.5 MEMCLK
EPP Profile 0 Minimum Cycle at supported CAS 2.00 ns / 17.00 ns (500 MHz)
EPP Profile 0 CAS Latency Undefined
EPP Profile 0 Minimum RAS to CAS delay (tRCD) 12.25 ns
EPP Profile 0 Minimum Row Precharge Time (tRP) 14.00 ns
EPP Profile 0 Minimum Act. to Precharge time (tRAS) 56 ns
EPP Profile 0 Write Recovery Time (tWR) 12.00 ns
EPP Profile 0 Minimum Active to Active/Refresh Time (tRC) 13.25 ns
EPP Profile 1 Voltage Level Undefined
EPP Profile 1 Address Command Rate 1T
EPP Profile 1 Address Drive Strength 1.00x
EPP Profile 1 Chip Select Drive Strength 1.00x
EPP Profile 1 Clock Drive Strength 1.25x
EPP Profile 1 Data Drive Strength 0.75x
EPP Profile 1 DQS Drive Strength 0.75x
EPP Profile 1 Addr/CMD Fine Delay 0/64 MEMCLK Delay
EPP Profile 1 Addr/CMD Setup Time 1.0 MEMCLK
EPP Profile 1 Chip Select Fine Delay 0/64 MEMCLK Delay
EPP Profile 1 Chip Select Setup Time 1.0 MEMCLK
EPP Profile 1 Minimum Cycle at supported CAS 4.75 ns (211 MHz)
EPP Profile 1 CAS Latency Undefined
EPP Profile 1 Minimum RAS to CAS delay (tRCD) 16.25 ns
EPP Profile 1 Minimum Row Precharge Time (tRP) 11.25 ns
EPP Profile 1 Minimum Act. to Precharge time (tRAS) 48 ns
EPP Profile 1 Write Recovery Time (tWR) Undefined
EPP Profile 1 Minimum Active to Active/Refresh Time (tRC) Undefined
EPP Profile 2 Voltage Level Undefined
EPP Profile 2 Address Command Rate 2T
EPP Profile 2 Address Drive Strength 2.00x
EPP Profile 2 Chip Select Drive Strength 2.00x
EPP Profile 2 Clock Drive Strength 1.50x
EPP Profile 2 Data Drive Strength 1.50x
EPP Profile 2 DQS Drive Strength 1.50x
EPP Profile 2 Addr/CMD Fine Delay 31/64 MEMCLK Delay
EPP Profile 2 Addr/CMD Setup Time 1.0 MEMCLK
EPP Profile 2 Chip Select Fine Delay 31/64 MEMCLK Delay
EPP Profile 2 Chip Select Setup Time 1.0 MEMCLK
EPP Profile 2 Minimum Cycle at supported CAS Undefined
EPP Profile 2 CAS Latency Undefined
EPP Profile 2 Minimum RAS to CAS delay (tRCD) 63.75 ns
EPP Profile 2 Minimum Row Precharge Time (tRP) 63.75 ns
EPP Profile 2 Minimum Act. to Precharge time (tRAS) 255 ns
EPP Profile 2 Write Recovery Time (tWR) 63.75 ns
EPP Profile 2 Minimum Active to Active/Refresh Time (tRC) 63.75 ns
EPP Profile 3 Voltage Level Undefined
EPP Profile 3 Address Command Rate 2T
EPP Profile 3 Address Drive Strength 2.00x
EPP Profile 3 Chip Select Drive Strength 2.00x
EPP Profile 3 Clock Drive Strength 1.50x
EPP Profile 3 Data Drive Strength 1.50x
EPP Profile 3 DQS Drive Strength 1.50x
EPP Profile 3 Addr/CMD Fine Delay 31/64 MEMCLK Delay
EPP Profile 3 Addr/CMD Setup Time 1.0 MEMCLK
EPP Profile 3 Chip Select Fine Delay 31/64 MEMCLK Delay
EPP Profile 3 Chip Select Setup Time 1.0 MEMCLK
EPP Profile 3 Minimum Cycle at supported CAS Undefined
EPP Profile 3 CAS Latency Undefined
EPP Profile 3 Minimum RAS to CAS delay (tRCD) 63.75 ns
EPP Profile 3 Minimum Row Precharge Time (tRP) 63.75 ns
EPP Profile 3 Minimum Act. to Precharge time (tRAS) 255 ns
EPP Profile 3 Write Recovery Time (tWR) 63.75 ns
EPP Profile 3 Minimum Active to Active/Refresh Time (tRC) 63.75 ns

Kannste z.b. hier hochladen

Filepoint

joar per email sollte das auch passen ich schick dir mal ne pn

Danke!

Und hier ein test

http://www.planet3dnow.de/vbulletin/sho ... p?t=314614